Factory direct since 2019 · OEM & ODM · EXW / FOB / CIF / DDP Sales reply within 6 hours

Static Mixing Nozzles, Mixer Tubes & Epoxy Mixers

Disposable and refillable spiral mixers from 83.7 mm to 369 mm. Element count and length are chosen against the ratio and viscosity of the adhesive, not the cartridge alone — a 10:1 system needs more elements than a 1:1 system at the same volume. Inlet style matters just as much: bell mouth, bayonet and multi-fit inlets are not interchangeable, and a mixer that will not seat will leak at the joint long before any mixing problem appears.

Selection guide

How to choose static mixers

Elements before length

16 elements handle 1:1 and 2:1 systems cleanly. Step up to 18 for 4:1, 5:1 and 10:1, where the minor component has to be folded in rather than pushed.

Inlet geometry decides fit

Bell mouth, bayonet, multi-fit and stepped inlets are not interchangeable between cartridge families. Send the cartridge drawing and we match the inlet, not just the length.

Pressure drop matters on manual guns

Long, tight mixers raise the force needed at the trigger. On hand tools keep the bore generous; on pneumatic or 2K machines you can trade pressure for mixing length.

Buyer questions

Frequently asked questions

What is the difference between a bell mouth and a bayonet inlet?

A bell mouth inlet is a wide flared skirt that pushes over the cartridge outlet and seals on the outside of the flange — common on 400 ml and larger side-by-side cartridges. A bayonet inlet is a narrow hub with two lugs that twists and locks into the cartridge collar, common on 50 ml cartridges. They are not adaptable to each other with a washer or an O-ring.

How many mixing elements do I need?

16 elements cover most 1:1 and 2:1 systems. Move to 18 or more for 4:1, 5:1 and 10:1, where the small B stream has to be folded into the main flow rather than simply pushed along. More elements than the adhesive needs buys pressure drop and retained material, not better mixing.

Helical or square mixer — which mixes better?

Helical elements reach a given mixing quality in a shorter length, which matters when the mixer has to fit inside a nozzle recess. Square (quadro) elements give a more uniform residence pattern across the bore and suit wide, slow beads. Neither is universally better; the choice follows viscosity and bead width.

Can a static mixer be cleaned and reused?

A spiral element set can be pulled out, soaked and refilled, and we supply that refillable version. The housing usually cannot be reused once cured adhesive has keyed into the element stack, so most production lines treat mixers as disposable and order in bulk.

Need a drawing matched, not a catalogue part?

Send the cartridge, adhesive datasheet or sample and we will confirm the matching part, tooling cost and lead time in one reply.

Request a quote